Sharechat Logo

Forum Archive Index - September 2001

Please note usage of the Forum is subject to the Terms & Conditions.

 
Messages by Date [ Next by Date Previous by Date ]
Messages by Thread [ Next by Thread Previous by Thread ]
Post to the Forum [ New message Reply to this message ]
Printable version
 

Re: Re: [sharechat] US Dollar


From: "G Stolwyk" <stolwyk@wave.co.nz>
Date: Fri, 21 Sep 2001 12:56:36 +1200


I feel that there are many facets to the low dollar:
 
For a start, NZ has been able to import cheap Chinese goods in the last few years. This may not remain so.
 
A country with a strong currency has more room to move. Interest rates of such a country are relatively low. Interest rates in a country like NZ are relatively high.
 
And Brash needs to constantly keep an eye on the outflow of capital should he reduce these rates before the bulk of the others do.
 
A low NZ dollar can invite other countries to show takeover interest in NZ export sensitive goods, eg. tourism or farmland, wine producing areas.
 
True, a low dollar is beneficial to farmers and in these times enable a country to compete. And, past Reserve Bank policies which created a high dollar, have not worked.
 
Thus, a lower dollar may temporarily suit a country with predominantly commodity exports.
 
But even if we did have a much higher dollar and we could  
buy overseas assets much cheaper, then we still need the skills to run larger companies: There is a tendency to destroy capital in a big way!
 
I found out years ago that these skills were not there and Ron Brierly confirmed that by referring to the then Brierly Board. A very good reason why he left. 
 
I believe that the Agrarian sector has these skills so far. That is understandable. 
 
Gerry    
 

Replies

 
Messages by Date [ Next by Date: Re: Re: [sharechat] US Dollar Jeremy
Previous by Date: [sharechat] Tas Ag & SCL Wedde, John ]
Messages by Thread [ Next by Thread: Re: Re: [sharechat] US Dollar Jeremy
Previous by Thread: Re: [sharechat] US Dollar Jeremy ]
Post to the Forum [ New message Reply to this message ]