Sharechat Logo

Forum Archive Index - May 2001

Please note usage of the Forum is subject to the Terms & Conditions.

 
Messages by Date [ Next by Date Previous by Date ]
Messages by Thread [ Next by Thread Previous by Thread ]
Post to the Forum [ New message Reply to this message ]
Printable version
 

Re: [sharechat] RE:CEN


From: "Nigel Barker" <nbarker@anzco.co.jp>
Date: Tue, 22 May 2001 15:54:38 +0900



It was a bit tricky..
The DFM site wouldn't accept another code either.
I think you would have needed to do place a phone order.
So much for technology?

Nigel

----- Original Message -----
From: "J JB" <bustedsausage@hotmail.com>
To: <sharechat@sharechat.co.nz>
Sent: Tuesday, May 22, 2001 2:01 PM
Subject: [sharechat] RE:CEN


> Does this mean that when placing your order one needed a seperate code
than
> CEN......the asb site doesn't even recognise CENZ.
>
> I don't understand how i was supposed to participate?????????
> _________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
>
>
> --------------------------------------------------------------------------
--
> http://www.sharechat.co.nz/          New Zealand's home for market
investors
> --------------------------------------------------------------------------
--
> To remove yourself from this list, please use the form at
> http://www.sharechat.co.nz/forum.shtml.
>


----------------------------------------------------------------------------
http://www.sharechat.co.nz/          New Zealand's home for market investors
----------------------------------------------------------------------------
To remove yourself from this list, please use the form at
http://www.sharechat.co.nz/forum.shtml.

References

 
Messages by Date [ Next by Date: Re: [sharechat] AQL Nick McVerry
Previous by Date: [sharechat] AQL tonysw ]
Messages by Thread [ Next by Thread: [sharechat] Contact Stand Philip Robinson
Previous by Thread: [sharechat] RE:CEN J JB ]
Post to the Forum [ New message Reply to this message ]